Accessories for Garmin StreetPilot III

Replacement GA 26C low-profile remote automobile antenna

This new and improved remote antenna runs on a lower voltage so battery drain is minimized. Comes with two mounting options. Magnetic mount for the outside of your vehicle or boat. Suction mount holds antenna in place against the inside of your windshield or window. With 8 feet of cable and BNC connector.

NEOPRENE 2 COMPARTMENT TRAVEL CASE

The protective neoprene prevents exposing your GPS unit to rain, dirt or other damaging elements.

Note: Neoprene Cases are WATER RESISTANT, not waterproof (i.e. cannot be submersed in water)

• Two padded compartments to protect both your GPS and accessories.
• Shoulder strap and handles for your travel convenience
• Scratch Protection
• Shock Absorption
• Dimensions: 6.5" x 4.5" x 4.5"

DELUXE CARRYING CASE 

128MB Data Card

MapSource City Navigator Australia CD

 Trip & Waypoint Manager

MapSource WorldMap CD

MapSource Topo US CD

City Navigator Europe

MapSource City Select
South Africa CD

USB Data Card Programmer

No more twiddling your thumbs and burning your GPS batteries while you download map detail to the data card. The USB data card programmer downloads maps directly to the data card in a fraction of the time. Connects to the USB port on your PC.

City Navigator Middle East

GA 29 Low Profile Marine Antenna
with 30ft Cable & BNC

If you're mounting your GPS unit below deck, you'll need this remote marine antenna to receive GPS signals. Comes with 30 feet of cable and BNC connector. (Can be mounted flush or pole.)

External Speaker System
with 12-volt Adapter

This accessory is a replacement for the 12-volt adapter cable with external speaker that came with your StreetPilot III. It allows you to power your unit off the vehicle's battery and hear the voice prompts. So if you need a new one, don't delay. You'll be lost without it.

 
AC / PC adapter, USA, 4 pin

This adapter allows you to connect your GPS unit to AC power (U.S., 110-volt) and to your PC. Features standard 9-pin D connector.

 
PC Cable (Included with GPS)

This cable allows you to make a powerful connection between your GPS and your PC. Create routes and waypoints on your PC and transfer them to your GPS. You can also download map detail from MapSource CD-ROMs to compatible units. Cable features a standard 9-pin D connector. Does not provide wiring for external power.

Dashboard Mount

Your GPS really gets around. Better get this dashboard mounting base so you can use it in a second vehicle. Temporary and permanent adhesive disks included.

 
Portable Mount (no installation)

For use with automotive mounting brackets

 
GA 26/27 series Antenna Suction Cup Mount (replacement)

So the suction cup mount that came with your GA 26/27 or GA 26C/27C antenna is gone and you're lost without it. No problem. Here's the replacement.

SUN SHADE VISOR

 
GA 28/GPS35/GPS36 series
Flange Antenna Mount

If you're mounting a GA 28 antenna to a thin surface, such as the outside of an RV, boat, or car, add some structural strength with this sturdy, one-piece flange mount.

 
GA 26/27 series Flange Antenna Mount

If you're mounting a GA 26/27 and GA 26C/27C antenna to a thin surface, such as the outside of an RV, boat, or car, add some structural strength with this sturdy, one-piece flange mount.

 
Temporary Adhesive Disk, 3 pack

8ft Extension Cable for
GA 26 series Antenna

If the 8 feet of cable that comes with the GA 26C remote antenna isn't enough, here's another 8 feet.